labelit(1m) 맨 페이지 - 윈디하나의 솔라나라

개요

섹션
맨페이지이름
검색(S)

labelit

Name
     labelit - list or provide labels for file systems

Synopsis
     labelit [-F FSType] [-V] [-o FSType-specific-options] special
          [operands]

Description
     The labelit utility is used to write or  display  labels  on
     unmounted disk file systems.

Options
     The following options are supported:

     -F FSType
                  Specify the FSType on  which  to  operate.  The
                  FSType  should  either  be specified here or be
                  determinable from /etc/vfstab by  matching  the
                  special  with  an  entry  in  the  table. If no
                  matching entry is found, the default file  sys-
                  tem  type  specified in /etc/default/fs will be
                  used.


     -V
                  Echo complete command line. This option may  be
                  used  to  verify and validate the command line.
                  Additional   information   obtained   using   a
                  /etc/vfstab  lookup  is included in the output.
                  The command is not executed.


     -o
                  Specify FSType-specific options. See the manual
                  page  for  the  labelit  module specific to the
                  file system type.

Operands
     The following operands are supported.  If  no  operands  are
     specified, labelit will display the value of the labels.

     special
                 The     disk     partition     (for     example,
                 /dev/rdsk/c0t3d0s6).  The device may not be on a
                 remote machine.


     operands
                 FSType-specific  operands.  Consult  the  manual
                 page  of the FSType-specific labelit command for
                 detailed descriptions.

Usage

     See largefile(5) for the  description  of  the  behavior  of
     labelit  when  encountering files greater than or equal to 2
     Gbyte ( 2^31 bytes).

Exit Status
     The following exit values are returned:

     0
                 Write or display of labels was successful.


     non-zero
                 An error occurred.

Files
     /etc/vfstab
                        List of default parameters for each  file
                        system.


     /etc/default/fs
                        Default local file system  type.  Default
                        values can be set for the following flags
                        in /etc/default/fs. For example:

                        LOCAL=ufs
                        LOCAL
                                     The default partition for  a
                                     command   if  no  FSType  is
                                     specified.

Attributes
     See attributes(5) for descriptions of the  following  attri-
     butes:



     tab() box; cw(2.75i) |cw(2.75i) lw(2.75i) |lw(2.75i)  ATTRI-
     BUTE TYPEATTRIBUTE VALUE _ Availabilitysystem/core-os

See Also
     labelit_hsfs(1M),     labelit_udfs(1M),     labelit_ufs(1M),
     volcopy(1M), vfstab(4), attributes(5), largefile(5)

Notes
     This utility may not be supported for all FSTypes.
맨 페이지 내용의 저작권은 맨 페이지 작성자에게 있습니다.
RSS ATOM XHTML 1.0 CSS3